Paragon Paraflyte Dive Stand, Ladder-at-Side, 3M Topflyte, Flanged Pedestal

Made for Durafirm short stand (fulcrum and anchor/hinged assembly). Recommended only for competition pools and only for 16’ Duraflex or Maxiflex boards. Ladder at side (as shown) or can be mounted at rear if specified. Utilizes 19” steps. Comes with flanged pedestal only. Guard rails and hand rails are welded and extend to pool edge. Durafirm fulcrum and anchor/hinged assembly are not included and must be ordered separately. Optional anchors available.

Paragon diving towers offer significant differences to satisfy varying needs, including budgets, preferences, and job conditions. Depending upon model, sizes vary from 1/2 meter to 3 meters in height. Paraflyte towers are available in one meter and three meter models.

Each tower is furnished complete with railings, rear anchor, front anchor, pedestal, and fulcrum. These can be varied to suit specific job requirements or specifications. Models satisfy most pool configurations, however, custom designs are available. Specification sheets, AutoCAD® drawings and Revlt models are available for each model.Anchors are included and are shipped with each tower. Anchors needed in advance for construction purposes can be ordered by identification numbers.

Standard tower pedestals come in red prime coat, ready for painting to match your facility, or in stainless steel (at extra cost), with flanged base.

Each Paraflyte tower is available in several different grades. The variations among grades apply only to materials. There is no difference in design or detail between grades of the same tower.

Specify Diving Board: Although a diving board is not included, the tower is fabricated to accommodate the type and length board to be used. Fabrication and setting dimensions may vary dramatically among boards.

Paragon Paraflyte Diving Towers are available in three different grades. The variation among the grades applies only to materials. The three grades are: Ultraflyte, Superflyte and Topflyte.

• Ultraflyte is the top grade and all tube is 1.90" O.D. × 0.145" wall T304 stainless steel.
• Superflyte is a general-purpose middle grade and all tube is T304 stainless 1.90" O.D. with a wall thickness range of 0.145", 0.109" or 0.65". The wall thickness of each member is dependent on structural requirements.
• Topflyte is the economy grade and all tube (with the exception of the flexural members) is T304 stainless steel tube 1.90" O.D. × 0.145" wall.

Each tower is designed for diving boards 14 or 16 feet long and is furnished complete with pedestal, front anchor, rear anchors, fulcrum and railings. These can be varied to suit specific job requirements or specifications.

Individual specification sheets are available for all models on request.

This diving equipment should be used only on pools that conform to state or local codes, FINA, NCAA, NFSHSA and US Diving standards. These specify minimum dimensions for depth of water, length and shape of diving hopper, location of diving boards with respect to side and vertical clearances, and any other requirements.

When ordering, we will contact you to discuss other information needed prior to preparing your order.

This item ships by Truck. Additional charges will apply if the following services are required:

• Shipment to a residential or military base address (charge varies, approximately $40 to $100)
• Shipment requiring inside delivery or a lift gate (charge varies, approximately $75 to $125)
• Expedited Service

Please specify during the checkout process in the Comment/Note section if you will need any additional services (such as those listed above) upon delivery. You will be contacted for approval prior to processing your order if any additional charges apply.